Mobile Action Technology Inc. 16H66R1 Manuel D’Utilisation

User Manual

Q-66HR

Q-Band

EN

Wear Q-66HR on your wrist

Charge your Q-66HR

Fasten Q-66HR with clasp

Change the wristband

Put on the wristband with the screen facing up and the band

wrapped around your wrist. Align the clasp along the band to 

find the holes where best fit the clasps.

Squeeze both clasps into the holes on the wristband until you 

hear a click, indicating the band is securely fastened.

Spread open both bands with the screen facing up, and press down the screen 

with your thumb until the core comes off the wristband.

Insert the core with screen facing up into the notch from below the wristband. 

Make sure the two tenons on each side of the core are securely fixed into the 

corresponding slots in the bands.

Button up the clasp on the side of the band with 2 holes. Please note that the 

charging contact should be near the clasp.

Important Notice: 

Failure to follow the instructions above might cause damage to the device.

1. 

2.

3.

Wristband

Clasp

Core

Touch Button

Metallic contact for charging

Optical Sensor

To charge your Q-66HR, place it in the charging box at the 

other end of the USB cable. Close the box afterwards, and 

make sure the Q-66HR is securely covered. Plug the USB 

connector to either a PC or power adapter to start charging.