Kenure Developments Ltd CFGTL Manuel D’Utilisation
ConfigTool User Manual
Model: ConfigTool FCC ID: Q8Q-CFGTL
BluTower Inc
www.blutower.com
US Office
2855 South Pine Avenue, Ocala, FL 34471 Tel 352-624-8695
2855 South Pine Avenue, Ocala, FL 34471 Tel 352-624-8695
© 2016 BluTower Inc. The information contained herein is the property of BluTower Inc and is supplied without liability for errors or
omissions. No part may be
reproduced or used except as authorized by contract or other written permission. All other company names, brand names, and product
names are the property of their respective holder(s).
ConfigTool Installation Instructions Rev1.1
omissions. No part may be
reproduced or used except as authorized by contract or other written permission. All other company names, brand names, and product
names are the property of their respective holder(s).
ConfigTool Installation Instructions Rev1.1
Description
The ConfigTool is a USB powered device used
for communicating with SmartRoute Endpoints
which are a part of the SmartRoute AMI System.
SmartRoute is designed to automatically and
remotely gather readings from a number of Water
Meters located within a defined area.
ConfigTool provides a short range radio interface
used during installation and commissioning of
Smart Route endpoints. It can also be used to
update endpoint firmware and collect diagnostic
data from endpoints.
for communicating with SmartRoute Endpoints
which are a part of the SmartRoute AMI System.
SmartRoute is designed to automatically and
remotely gather readings from a number of Water
Meters located within a defined area.
ConfigTool provides a short range radio interface
used during installation and commissioning of
Smart Route endpoints. It can also be used to
update endpoint firmware and collect diagnostic
data from endpoints.
Specification
Power Supply:
+5VDC USB
Operating Frequency:
920MHz
Required Equipment
The following items are required to operate
ConfigTool:
ConfigTool:
•
Computer running Windows 7 or 10.
•
ConfigTool software application and
driver
driver
Operation Instructions
1.
Install the ConfigTool in to a vacant
USB slot.
USB slot.
2.
Confirm that ConfigTool has been
recognized by the Computer
recognized by the Computer
3.
Open the ConfigTool application (refer
to the software user manual for further
details)
to the software user manual for further
details)
4.
To get the best wireless range avoid
using in close proximity to any other
objects or people.
using in close proximity to any other
objects or people.
General Warnings and Safety
Warning Changes or modifications to the product
not expressly approved by BluTower could void
the user’s authority to operate the equipment.
See FCC information below.
This sheet provides instructions needed to
successfully connect and configure the
ConfigTool for use. These instructions are only a
supplement to training in the operation of the
product. For further training information, contact
BluTower directly.
not expressly approved by BluTower could void
the user’s authority to operate the equipment.
See FCC information below.
This sheet provides instructions needed to
successfully connect and configure the
ConfigTool for use. These instructions are only a
supplement to training in the operation of the
product. For further training information, contact
BluTower directly.
Regulatory Information
FCC Part 15 Regulation
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Safety
This device has been designed and complies with
the safety requirements for portable RF exposure
in accordance with FCC rule part 2.1093 and
KDB 447498 D01.