Cardo Systems ER16 Manuel D’Utilisation

NOTE:  Pairing will replace any existing paired device with the new 

If you have purchased the Q1 TeamSet, the retail package contains 

1.  Check both scala riders are in Standby (single BLUE flash every 

3 seconds).

2.  On the Q1, press and hold the “IC” button for 5 seconds. The 

LED will begin flashing RED and the Q1 will now be in intercom 

pairing mode. 

3.  Enter intercom pairing mode on the second unit by following 

the device’s instructions. Both units will now be in intercom 

pairing mode.

4.  After a few seconds, the Q1 will show a solid RED light for 2 

seconds, indicating that it is paired and ready to use.

NOTE: If Pairing is not completed within two minutes, the units will 

Tap “IC”  or speak any word loudly into the 

microphone to call via VOX

Tap “IC”  

Use VOX to make Intercom Calls using only your voice (see section 

4.6). VOX Intercom calls will end automatically after 30 seconds of 

silence.

IMPORTANT: VOX and AGC performance will vary based on 

•  If another paired scala rider tries calling you via Intercom, the call 

will begin almost instantly

• To receive a CTL intercom call see table in section 5.5

5.5 CLICK-TO-LINK® INTERCOM

Click-to-Link is the spontaneous, “social” feature of your scala rider. 

Use Click-to-Link to make intercom calls with other scala rider 

users near you without pre-pairing.

Click-to-Link can be disabled on your Q1 effectively blocking any 

attempt by others to make Click-to-Link calls to you.

Start a CTL call request 

(search lasts up to 10 seconds)

In standby, press “MM” for 2 seconds

End a CTL call /  

Cancel a CTL call request

Tap “IC”

Accept a CTL call

When hearing the CTL ringtone:

Tap “IC” or say any word loudly to 

answer by VOX

Reject a CTL call

Remain silent until the CTL ringtone 

stops or press “IC”  for 2 seconds

ENABLE/DISABLE CTL 

(Default: ENABLED)

Via the Voice Menu (see section 4.5) or via 

the Cardo Community

|