SendFar Technology Co. Ltd. MPI-04001 Manuel D’Utilisation

1)  The antenna must be installed such that 20 cm is maintained between the 

antenna and users, and   

2)  The transmitter module may not be co-located with any other transmitter 

or antenna. 

As long as 2 conditions above are met, further transmitter test will not be 

required. However, the OEM integrator is still responsible for testing their 

end-product for any additional compliance requirements required with this 

module installed (for example, digital device emissions, PC peripheral 

requirements, etc.). 

 

IMPORTANT NOTE: In the event that these conditions can not be met (for 

example certain laptop configurations or co-location with another transmitter), 

then the FCC authorization is no longer considered valid and the FCC ID can 

not be used on the final product. In these circumstances, the OEM integrator 

will be responsible for re-evaluating the end product (including the transmitter) 

and obtaining a separate FCC authorization. 

 

This transmitter module is authorized only for use in device where the 

antenna may be installed such that 20 cm may be maintained between the 

antenna and users 

(for example: AP, Notebook…etc.).

 The final end product 

must be labeled in a visible area with the following: 

“Contains TX FCC ID: 

QA5-MPI-04001”.

 

 

The OEM integrator has to be aware not to provide information to the end 

user regarding how to install or remove this RF module in the users manual of 

the end product which integrate this module. 

 

The users manual for OEM integrators must include the following information 

in a prominent location “ IMPORTANT NOTE: To comply with FCC RF 

exposure compliance requirements, the antenna used for this transmitter 

must be installed to provide a separation distance of at least 20 cm from all 

persons and must not be co-located or operating in conjunction with any other 

antenna or transmitter.