SendFar Technology Co. Ltd. ORB-02001 Manuel D’Utilisation

Figure 4-2 General Configuration – System Setup-2

Host Information

- Host Name. The Host Name is not an essential setting, but it helps
identify the device in network. Use this setting to assign a name to the
device.

Operation Mode

The First Thing You Have To Do

Select an operation mode,

and click FINISH to refresh this page

Central Bridge

Select the Central Wireless Bridge mode. And then set the corresponding
parameters.

- Bridge IP Address.

Use this setting to assign or change the bridge’s IP

address.

- Bridge Subnet Mask. Enter an IP subnet mask to identify the sub
network so the IP address can be recognized on the LAN.

Default Route IP

- IP Address. Enter the default Gateway IP Address.

After that, click FINISH at the bottom of this page to complete the
modification of this page.

Remote Extension Bridge

Select the Remote Wireless Bridge mode. And then set the corresponding
parameters.

- Bridge IP Address.

Use this setting to assign or change the bridge’s IP

address.

- Bridge Subnet Mask. Enter an IP subnet mask to identify the sub
network so the IP address can be recognized on the LAN.

Default Route IP

- IP Address. Enter the default Gateway IP Address.

After that, click FINISH at the bottom of this page to complete the
modification of this page.

Central Router with PPPoE Client Ethernet connection

If you are an ADSL subscriber, you need to specify that you personal ISP
PPPoE Username and Password to enable ADSL broadband access.

- PPPoE User Name. This setting allows you to enter the user name that
your ISP assigns to your account.

- PPPoE Password. Enter the password that your ISP assigns to your
account.

- Password Confirm. Enter the PPPoE Password once more again.