SendFar Technology Co. Ltd. ORB-04002 Manuel D’Utilisation
70
3.7.3 Wireless Link Info
1. Click Utility, select Wireless Link Info page (as shown in Figure 3-29),
and then you can view the Link Quality and the Signal Strength of this
wireless connection.
wireless connection.
2. The Link Quality and the Signal Strength are valid only in the role of
Remote RB. In here, you can also see the quality level for this wireless
connection.
connection.
Figure 3-29
71
Chapter 4. Telnet configuration
The RB is designed to operate as shipped from the factory without any special set-
up. However, it has many options and parameters that can be changed if users
have special requirements. Most of the management functions can be accessed
using TCP/IP protocol, it also configured by Telnet/Console.
The user can use a LAN attached (wired or wireless) computer to
configure the RB through using a Telnet session on a LAN attached
computer. To use the Telnet session simply open a Telnet window
using the IP address which has been assigned to the RB.
1. Click Start button, select Run to open the Run dialog box. Enter telnet
192.168.2. 1(default terminal type of Telnet is VT100, default IP address
of the RB is 192.168.2.1). Then click OK as shown in Figure 4-1.
of the RB is 192.168.2.1). Then click OK as shown in Figure 4-1.
Figure 4-1.
2. In the Telnet window, enter the User Name and User Password as
shown in Figure 4-2 (default User Name and User Password is user1
and test) to see the main screen of Telnet user interface as shown in
Figure 4-3.
and test) to see the main screen of Telnet user interface as shown in
Figure 4-3.