Broadcom Corporation BRCM1005-D Manuel D’Utilisation
Using PC Cards
83
FILE LOCATION: S:\SYSTEMS\Pebble\UG\A00\English\pccards.fm
D E L L C O N F I D E N T I A L – P R E L I M I N A RY 1 / 2 9 / 0 3 – F O R P R O O F O N LY
1
Hold the card with its orientation symbol pointing into the slot and
the top side of the card facing up. The latch may need to be in the "in"
position before you insert the card.
2
Slide the card into the slot until the card is completely seated in its
connector.
If you encounter too much resistance, do not force the card. Check the
If you encounter too much resistance, do not force the card. Check the
card orientation and try again.
The computer recognizes most PC Cards and automatically loads the
appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the floppy disk or CD that came with the PC
Card.
appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the floppy disk or CD that came with the PC
Card.
Removing a PC Card or Blank
NOTICE: Use the PC Card configuration utility
on the taskbar to select
a card and stop it from functioning before you remove it from the computer. If
you do not stop the card in the configuration utility, you could lose data. Do not
attempt to eject a card by pulling its cable, if one is attached.
you do not stop the card in the configuration utility, you could lose data. Do not
attempt to eject a card by pulling its cable, if one is attached.
1
Press the eject button.