Broadcom Corporation BRCM1005-HC Manuel D’Utilisation

WIDCOMMinc  

 

Paired devices are always displayed in My Bluetooth Places, even if the remote device is 
out of range or not powered up. 
Verify that the remote member of the pair is within radio range and powered up, and then 
attempt the connection again. 

The remote device may not be powered up or may be out of range. 

• 
• 

• 

• 

• 

• 

• 
• 

Verify that the remote device is powered up. 
Verify that the remote device is in Connectable mode (Bluetooth Configuration 
Panel > Accessibility tab). 
Perform a Search for Devices to verify that the device is within range. 

The Dial-up Networking service will not start unless a properly configured modem is 
attached to the server.  

Verify that the modem is usable as a local device on the computer to which it is 
attached. 
In the Bluetooth Configuration Panel, Local Services tab, double-click the Dial-
up Networking service. 
Click the down arrow in the Modem field and select the modem that will be used 
to dial out. 
Click the OK button. 
Click the OK button to close the Bluetooth Configuration Panel. 

In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section, select 
the device you want to determine the address of. In the Device Properties section of the 
dialog box, the fourth entry, Device Address, is the BDA of the selected Bluetooth 
device. 

In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties 
section, the fifth entry provides Bluetooth Specification compliance information for the 
Host Controller Interface. 
The sixth entry contains the Specification Revision information for the Host Controller 
Interface, if appropriate. 

In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties 
section, the seventh entry provides Link Manager Protocol version number information. 
The eighth entry contains the Link Manager Protocol sub-version number information, if 
appropriate.