Broadcom Corporation BRCM1017 Manuel D’Utilisation
578-100-097 Revision C
Page 1 of 2
*578-100-097C*
*578-100-097C*
Compliance Statement Insert
Device Name: Data Collection Computer
Model Number: CV60
The responsible party for the compliance of this device is:
Intermec Technologies Corporation
6001 36
th
Avenue West
Everett, WA 98203
USA
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals approved by
Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this product that are not approved by
Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the users authority to operate the
equipment.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the radio of television receiving antenna.
•
Increase the separation between the computer equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
•
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
This device contains radio frequency transmitters approved by the Federal Communications Commission under FCC ID: EHABTM210 and
FCC ID: QDS-BRCM1017 .
WARNING: Per the FCC radio frequency (RF) exposure requirements,
(1) Antennas must be supplied and installed as recommended by Intermec Technologies Corporation to insure compliance to RF exposure
(1) Antennas must be supplied and installed as recommended by Intermec Technologies Corporation to insure compliance to RF exposure
requirements. The integral antennas approved for use are not to be serviced by the user.
(2) When installing and using Intermec CV60, a 20-cm (8-inch) passing distance must be maintained from any body part of the user or nearby
persons and the antennas at the top of the unit. The antenna area must not be touched during transmitter operation.
(3) RF safety requirements mandate this device cannot be co-located with other transmitters.