Broadcom Corporation BRCM1019 Manuel D’Utilisation
Additional information on the potential energy and financial savings of the power management feature
can be found on the EPA ENERGY STAR Power Management Web site at
can be found on the EPA ENERGY STAR Power Management Web site at
Additional information on the ENERGY STAR program and its environmental benefits are available on
the EPA ENERGY STAR Web site at
the EPA ENERGY STAR Web site at
.
Laser compliance
This product may be provided with a device containing a laser that is classified as a Class 1 Laser
Product in accordance with US FDA regulations and the IEC 60825-1. The product does not emit
hazardous laser radiation.
Product in accordance with US FDA regulations and the IEC 60825-1. The product does not emit
hazardous laser radiation.
Each laser product complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser
Notice No. 50, dated May 27, 2001; and with IEC 60825-1:1993/A2:2001.
Notice No. 50, dated May 27, 2001; and with IEC 60825-1:1993/A2:2001.
WARNING!
Use of controls or adjustments, or performance of procedures other than those specified
in the laser product installation guide, may result in hazardous radiation exposure. To reduce the risk
of exposure to hazardous radiation:
of exposure to hazardous radiation:
Do not try to open the module enclosure. There are no user-serviceable components inside.
Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specified in the laser product installation guide.
specified in the laser product installation guide.
Allow only authorized service providers to repair the unit.
Modem notices
WARNING!
To reduce the risk of fire, electric shock, and injury to persons when using this device,
always follow basic safety precautions, including the following:
Do not use this product near water—for example, near a bathtub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.
tub, in a wet basement, or near a swimming pool.
Avoid using this product during an electrical storm. There is a remote risk of electric shock from lightning.
Do not use this product to report a gas leak while in the vicinity of the leak.
Always disconnect the modem cable before opening the equipment enclosure or touching an
uninsulated modem cable, jack, or internal component.
uninsulated modem cable, jack, or internal component.
If this product was not provided with a telephone line cord, use only No. 26 AWG or larger
telecommunication line cord.
telecommunication line cord.
Do not plug a modem or telephone cable into the RJ-45 (network) jack.
SAVE THESE INSTRUCTIONS
Telecommunications device approvals
The telecommunications device in the computer is approved for connection to the telephone network in
the countries and regions whose approval markings are indicated on the product label located on the
bottom of the computer or on the modem.
the countries and regions whose approval markings are indicated on the product label located on the
bottom of the computer or on the modem.
Laser compliance
11