Broadcom Corporation BRCM1035 External Photos
Broadcom Corporation
Request for transmitter modular approval
FCC ID: QDS-BRCM1035
Transmitter Module Characteristics
Item Requirements
EUT
1
Have its own RF shielding
Device is equipped with
Metal shielding to cover RF
section. Refer to external
photos
Metal shielding to cover RF
section. Refer to external
photos
2
Have buffered modulation/data inputs (if such
inputs are provided),
inputs are provided),
All inputs to the modules are
buffered through logic or
microprocessor inputs.
buffered through logic or
microprocessor inputs.
3
Have it own power supply regulation
Internal 3.0V, 1.8V, and
1.2V regulator.
1.2V regulator.
4
Meet the antenna requirements of Section
15.203
15.203
IFA antenna with I-PEX
connector
connector
5
Be tested in a stand-alone configuration, i.e., the
antenna, AC or DC power and data input/output
lines must be connected to the module but, the
module must not be inside another case during
testing
antenna, AC or DC power and data input/output
lines must be connected to the module but, the
module must not be inside another case during
testing
Device is tested external to a
host on an extender board in
a standalone configuration
host on an extender board in
a standalone configuration
6
Be labeled with its own FCC ID number, and if
the FCC ID is not visible when the module is
installed inside another device, then the outside
of the device into which the module is installed
must also display a label referring to the
enclosed module.
the FCC ID is not visible when the module is
installed inside another device, then the outside
of the device into which the module is installed
must also display a label referring to the
enclosed module.
FCC ID label format will be
included in the filing.
System ID label will by
displayed on the host system.
included in the filing.
System ID label will by
displayed on the host system.
7
The modular transmitter is manufactured so that
the user cannot influence the operation of the
transmitter that will operate outside of the scope
of the regulations.
the user cannot influence the operation of the
transmitter that will operate outside of the scope
of the regulations.
Refer to “User’s Guide”
Exhibit
Exhibit
8
Address compliance with the Commission's RF
exposure limits in Sections 1.1310 and 2.1093.
In addition, spread spectrum transmitters
operating under Section 15.247 are required to
address RF exposure compliance in accordance
with Section 15.247(b)(4).
exposure limits in Sections 1.1310 and 2.1093.
In addition, spread spectrum transmitters
operating under Section 15.247 are required to
address RF exposure compliance in accordance
with Section 15.247(b)(4).
MPE calculation is
provided to demonstrate
RF compliance for mobile
modular approval.
provided to demonstrate
RF compliance for mobile
modular approval.