Broadcom Corporation BRCM1036 Manuel D’Utilisation

Each laser product complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser
Notice No. 50, dated May 27, 2001; and with IEC 60825-1:1993/A2:2001.

Use of controls or adjustments, or performance of procedures other than those specified

in the laser product installation guide, may result in hazardous radiation exposure. To reduce the risk
of exposure to hazardous radiation:

Do not try to open the module enclosure. There are no user-serviceable components inside.

Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specified in the laser product installation guide.

Allow only authorized service providers to repair the unit.

To reduce the risk of fire, electric shock, and injury to persons when using this device,

always follow basic safety precautions, including the following:

Do not use this product near water—for example, near a bathtub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.

Avoid using this product during an electrical storm. There is a remote risk of electric shock from lightning.

Do not use this product to report a gas leak while in the vicinity of the leak.

Always disconnect the modem cable before opening the equipment enclosure or touching an
uninsulated modem cable, jack, or internal component.

If this product was not provided with a telephone line cord, use only 0.126 mm

2

 (No. 26 AWG) or larger

telecommunication line cord.

Do not plug a modem or telephone cable into the RJ-45 (network) jack.

SAVE THESE INSTRUCTIONS

The telecommunications device in the computer is approved for connection to the telephone network in
the countries and regions whose approval markings are indicated on the product label located on the
bottom of the computer or on the modem.

Refer to the user guide included with the product to ensure that the product is configured for the country
or region in which the product is located. Selecting a country or region other than the one in which it is
located may cause the modem to be configured in a way that violates the telecommunication regulations/
laws of that country or region. In addition, the modem may not function properly if the correct country
or region selection is not made. If, when you select a country or region, a message appears that states
that the country or region is not supported, this means that the modem has not been approved for use
in this country or region and thus should not be used.

This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA.
On the bottom of the computer or on the modem is a label that contains, among other information, a
product identifier in the format US:AAAEQ##TXXXX. Provide this information to the telephone company
if you are requested to do so.

Modem notices

13