HIT HBK001 Manuel D’Utilisation

4.  When pair is finished

 (*2)

, the device will enter standby mode. The green 

LED is flashing per 2 seconds. 

 

(*1)

    Only in standby mode, you can do pair procedure. 

    If you don’t sure which state is. You can plug-out and plug-in of car kit 

plug again and wait the green LED flash once per 2 seconds. This is 

standby mode now. 

 (*2) 

 

¡If green LED turn off 3~6 seconds, you need restart pair procedure 

again. 

     ¡ Once pair is successful, you needn’t do pair procedure next time unless 

you change another headset.   

 

 

 

1.  Plug audio cable into the headset ready mobile phone

(*3)

. 

2.  Maybe you need enable the auto answer function in your mobile   

phone.   

3.  It will auto transfer to the headset directly when the call in. 

Please adjust proper volume from your phone in order to avoid too much 

sidetone or distortion.  

4.  It will auto enter the standby mode or low power mode if headset supports 

for the power saving when ends call. It is like the hand-free in your 

Bluetooth headset. 

 

(*3)

 ¡Please refer to your wire headset plug header in order to select 3 

    or 4 nodes header of audio cable. 

  ¡Some mobile phones are not headset ready, they may need an 

                adapter in order to transfer to 2.5 

φ

 phone jack. 

 

 

Standby mode 

Green LED flash once/2 sec 

Pair mode 

Green LED flash  once/0.5 sec 

Talk mode 

Green LED flash once/1 sec