Technalogix Ltd. P379 Manuel D’Utilisation
P-379 Processor
16
5.0
O
PERATING
P
ROCEDURE
Preliminary Hook-up
1.
Position the Technalogix P-379 agile processor in its installation mount or rack.
2.
Locate the antenna lead or cable drop that will provide the input signal for the P-
379 agile processor.
379 agile processor.
3.
Ensure that the input signal provides an adequate signal. The recommended
input level for best performance from the Technalogix P-379 Processor is 0 to
+10dBmV (+60dBuV to +70dBuV).
input level for best performance from the Technalogix P-379 Processor is 0 to
+10dBmV (+60dBuV to +70dBuV).
Setup and Operation
1.
Connect the input-source cable drop or antenna lead to the F connector
On the rear panel of the P-379 marked “RF INPUT”.
NOTE: If you have a P-379T, also connect the T- or return-channel input source
cable to the F-connector on the rear panel of the P-379 marked “T-INPUT”.
cable to the F-connector on the rear panel of the P-379 marked “T-INPUT”.
2.
Connect the output of the P-379 to a 50 Ohms load via an RF cable connected to
the F-connector marked “RF OUTPUT” on the rear panel of the P-379.
the F-connector marked “RF OUTPUT” on the rear panel of the P-379.
3.
Connect the Technalogix P-379 to a proper AC electrical source. The correct
electrical input type for the unit is marked on the rear panel, directly under the
entrance of the power cord into the unit.
electrical input type for the unit is marked on the rear panel, directly under the
entrance of the power cord into the unit.
Exercise care in handling equipment during inspection to prevent
Damage due to rough or careless handling.
Technalogix power supplies are designed so that, under certain power
line or heat buildup conditions, the unit shuts off. An indication is no RF
output, although the POWER LED on the front panel remains illuminated.
If this occurs, unplug the power cord and wait at least two (2) minutes
before reapplying power. Upon reapplying power, you should again have
RF output. If the unit fails to provide RF output again, or should the unit
return to shutdown mode, telephone your distributor for assistance or call
Technalogix direct at 403-347-5400. Remember: Technalogix
recommends a 1.75” air circulation space between each piece of rack-
mounted equipment.
Technalogix power supplies are designed so that, under certain power
line or heat buildup conditions, the unit shuts off. An indication is no RF
output, although the POWER LED on the front panel remains illuminated.
If this occurs, unplug the power cord and wait at least two (2) minutes
before reapplying power. Upon reapplying power, you should again have
RF output. If the unit fails to provide RF output again, or should the unit
return to shutdown mode, telephone your distributor for assistance or call
Technalogix direct at 403-347-5400. Remember: Technalogix
recommends a 1.75” air circulation space between each piece of rack-
mounted equipment.