Advanced Control Technologies Inc. 0792-01 Manuel D’Utilisation

Z-Wave ZDW120 Instructions, Series 300, Release 3.10 

P/D 060210

 

0795-01

2

2.  Check connections to be sure they are tight and no bare conductors are exposed.
3.  Make sure the load or installation does not exceed the device rating.  
4.  Restore the power.

Wire this Wall Mounted Dimmer in place of an existing wall switch according to the diagram.  See the ZTH100 

Wireless Controller operating instructions to add this module under the command of the Wireless Controller.

Using ZDW120’s standard full heat-sink (all tabs), the connected incandescent lamp load shall not exceed 500W.
If a tab is removed from one side of the ZDW120 unit, the connected incandescent lamp load must not exceed 

400W.
If both tabs are removed from the ZDW120 unit, the connected incandescent lamp load must not exceed 300W.  

The connected incandescent lamp load must not exceed 400W for each of the two ZDW120 units.  

The connected incandescent lamp load must not exceed 300W for each of the two ZDW120 units.   

The ZDW120 has an air gap switch on the face (lower left), that when pulled out, completely removes the power 

available to the load (more so than simply turning the dimmer off).  This enables the lamps that are controlled 

by the device to be changed with minimal danger of electrical shock.  The air gap switch must be pushed all 

the way back in for the dimmer to operate the lamps again.

STEP 1..   Prepare the Controller to include a unit to the network by adding it to a group (method of adding a 

node to the network).  Refer to controller instructions.  

STEP 2.    The ZDW120 must be in its permanently installed location.  Tap either the top or bottom of the 

ZDW120 switch once.  

STEP 3.    You should see an indication on your Controller that the “DEVICE WAS INCLUDED” in the network. 

NOTE:  If you have trouble adding the ZDW120 to a group it may be that the Home ID and Node ID were not 

cleared from it after testing.  You must first “RESET UNIT” with your controller to remove it from the network.  

If using the ZTH100 select “SETUP” and scroll to “RESET UNIT” 
Although adding it to a group includes it in the network, removing it from a group does not remove it from the 

network.  If removed from a group, it functions only as a repeater.      

The ZDW120 allows the user to

•  

 Turn the load attached ON, OFF, DIM or BRIGHTEN.  

•  

 Include or exclude the module from the Z-Wave system

•  

 Control other Z-Wave enabled devices.

The top or bottom of the ZDW120 switch can be used to carry out inclusion (add to a group), association, exclu-

sion (remove from group) or reset (remove from network).    When a controller prompts you to “Send Node ID” 

or to “Press Button on Unit”, quickly tap on the top or bottom of the switch once to satisfy those instructions.

•  

 Tapping top of the switch turns the load attached ON.

•  

 Tapping bottom of the switch turns the load attached OFF.

•  

    Pressing and holding the top of the switch will brighten the load attached, and pressing and holding 

the bottom of the switch will dim the load.  When OFF, pressing and holding the bottom of the switch will 

cause the load will go to the minimum dim level. 

Note:  Upon restoration of power after a power loss, the ZDW120 defaults OFF.