Rehabtronics Inc. HSST1 Manuel D’Utilisation
47
Wireless Specifications
The following table details the wireless specifications for the STIM and HMS:
Operating Frequency Range 2403 – 2481 MHz
Operating Frequencies Uses 3 randomly-selected frequencies assigned to each unit
Data Rate 1 Mbps
Maximum Transmit Power 4 dBm
Modulation Scheme GFSK
Modulating Signal Type Binary Data
Modulation Baud Rate 1 MHz
Modulation Bandwidth 160 kHz deviation around the carrier
Receiver Bandwidth 160 kHz around the selected frequency
RF Frequency Channels 79 Channels
Channel Spacing Minimum 20 MHz, Maximum 25 MHz
Antenna Type Antenova; -1.9 dBi Average Gain; 0.8 dBi Peak Gain
Transceiver Duplex Scheme Time Division Duplexing
Bit Error Rate Less than 0.1%
Packet Error Rate Less than 5%
Receiver Sensitivity -86 dBm at 0.1% Bit Error Rate
Command Delay Maximum 1 Second
Transmitter Duty Cycle Less than 0.05%
Operating Range Up to 5 meters
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of this device.
Changes or modifications to this equipment not expressly approved by Rehabtronics Inc. could void the user’s
authority to operate the equipment.
NOTE: The Federal Aviation Administration rules require that all radio-transmitting devices be turned off during
flight.
This device complies with the Canadian Interference-Causing Equipment Standard #3 (ICES-003).
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.