Dakota Alert DCMT-4000 Manuel D’Utilisation

Coding transmitter to the DCR-4000

1) Remove 4 screws on back of transmitter and install 9 volt battery in DCMT-4000.

2) Follow CoDing Tune instructions in DCR-4000. 

3) To activate the transmitter, you can either wave your hand over the sensor or press the small white button on the circuit board (Figure 2).

opeRaTion: The DCMT will detect people or vehicles up to 100’ in front of the sensor. 

Mount the DCMT on a wall, post or tree about 3-4’ off the ground pointing towards the area to be monitored. Note: to avoid false signals, do not point to-

wards busy roads or ponds. LED setting: The LED jumper on the PCB can be set to “ON” so that the LED will light for a second when an object is detected or 

it can be set to “off” which would never let the LED light up when an object is detected. FILTER setting: The FILTER jumper should be set to “ON” for outdoor 

use and can be set to “OFF” for indoor use. Note: If more sensitivity is needed, the filter can be set to “OFF”. However, this might cause false signals out-

doors. RESET setting: The RESET jumper can be changed from 10 seconds to 120 seconds. This is the minimum time between activations. RANGE setting: 

The RANGE jumper can be set from High (H), Medium (M) and Low (L). The High setting will allow detection up to about 100’, the Medium setting will allow 

detection up to about 50’ and the Low setting will allow detection up to about 25’.

Volume is controlled with the VOLUME   button, 4 levels and OFF.

Press and release the VOLUME   button to select desired volume level.

1) Push and hold the MODE and VOLUME   buttons (Figure 1) for three seconds.

2) When all four lights flash, release the buttons. 

3) Press and toggle the VOLUME   button to select desired tune (12 different tunes to choose).

4) After you have chosen a tune, activate the transmitter and you will hear a beep from the DCR-

4000.

5) If you are coding more than one transmitter, repeat steps 3 and 4.

6) After the transmitter(s) are coded, press and hold the MODE and VOLUME   buttons for one 

second and release once the four lights flash.

7)  To  test  transmitter  tune,  activate  the  transmitter  and  you  will  hear  the  selected  tune  hear 

through receiver and the lights will flash. 

eRasing CoDing fRom DCR-4000, 
1) Push and hold the MODE and VOLUME   buttons for three seconds, you will see all 4 lights flash, then release.

2) Push and hold the MODE and VOLUME   buttons for five seconds, the 4 lights will flash, then release.

3) All the codes have now been erased. Repeat the CoDing Tune section for the 

various transmitters.

®

MODE button

VOLUME button

Figure 1

White button

Figure 2