Young Electronics Corporation. EMS3YOUNG Manuel D’Utilisation

or the receiver.(Note: The switches are in the "ON" positions

   Alternating from "ON" and "OFF" or "OFF" and "ON" position.

   order as the receiver for the transmitter to function properly.

   It is important for the access code to be set exactly in the same

   1. Standing approximately 10-30 feet away from the receiver,

   2. Stand in several different areas of usage to locate possible

3. Using a sharp object or tool, such as a paper clip, set the new

according to the exact code setting of your previous transmitter

possible for you to choose from.

DOOR(GATE)
Open/Close

LIGHT
This LED lamp helps
you see the key lock.

DOOR BUTTON
OPERATION
INDICATOR

2. Remove the two Philips head screws located on the back of the 

Code Switch

+

Top Case Removed

Transmitter with

-

QUICK REFERENCE FOR

TRANSMITTER BUTTONS

DIAGRAM #1

ACCESS-318

the circuit board and battery.(See Diagram #1)

case and carefully separate the case halves to expose 

Battery

Testing the Transmitter

     push the transmitter button to activate.

points where certain structures may interfere with
the transmission.

4. Once the codes have been set, replace the top cover,

   Note: In order to avoid duplication of your access code,

   Setting the switch on all "ON" or all "OFF" position.

the following sequences are not recommended.

   and test the system.

The,ACCESS318, is the mini transmitter designed for the garage

1. Determine the 10 digit access code obtained from the previous

PRODUCT INSTRUCTION 

door opener and gate operators for home,farm and ranch etc...

OPERATING INSTRUCTIONS:

   transmitter or the receiver.

However there are over hundreds of combinations of codes

Code Setting

ACCESS 318 mini Transmitter

   transmitter code by setting the "ON" and "OFF" switches

8

when the switch is pushed toward the letter ON.)

ON

1

4

3

2

5

7

6

(See Diagram #2)

Code Switch

DIAGRAM #2

9

interference in a residential installation. This equipment

- Consult the dealer or an experienced radio/TV

different from that to which the receiver is connected.

- Connect the equipment into an outlet on a circuit

interference will not occur in a particular installation.
If this equipment does cause harmful interference to

by turning the equipment off and on, the user is

radio or television reception, which can be determined

- Increase the separation between the equipment 

encouraged to try to correct the interference by one or 

generates,uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that 

more of the following measures:

technician for help.

and receiver.

- Reorient or relocate the receiving antenna.

   J  ELECTRONICS & CO.

C
TORRANCE CALIFORNIA

DISTRIBUTED BY

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmfull interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

party responsible for compliance could void the user's

Caution: Any changes or modifications in construction

of this device which are not expressly approved by the

provide  reasonable  protection  against  harmful 

part 15 of the FCC Rules. These limits are designed to

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

1. Output Power : -37dBm

5. Lighting LED Lamp

3. Power Supply : 12Vdc(5Vdc Regulation)
4. Operation Indicate LED Lamp

2. Output Frequency : 300MHz

General specfication & Feature

authority to operate the equipment.