3e Technologies International Inc. 523E-900 Manuel D’Utilisation
AirGuard WiMesh 3e-
523 Series User’s Guide
Copyright
2015 Ultra Electronics, 3eTI
October 2015
82
29000169-005 Revision C1
3. WiMesh End Points 3e-523A and 3e-523E-900 Hardware
Installation
3.1 3e-523A Hardware Installation
Preparation for Use
This section deals with installation of the 3e
–523A unit. The unit requires physical mounting and
installation on the site, following a prescribed placement design to ensure optimum operation.
The package includes the following items:
The Device
Documentation as PDF files (on CD-ROM)
Registration and Warranty cards
The device has the following available accessories:
Outdoor Accessory Kit (3e-523-OAK)
Indoor Accessory Kit (3e-523-IAK)
DIN Rail Accessory Kit (3e-523-DINR-IN)
The device can be mounted outdoors on a high post to achieve the best bridge result. If mounted outdoors,
the outdoor accessory kit must be used to prevent lightning damage.
the outdoor accessory kit must be used to prevent lightning damage.
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, the antennas
used with the 3e-523A must be installed with a minimum separation distance of
21.5 cm from all persons, and must not be co-located or operated in conjunction
with any other antenna or transmitter. Installation should be accomplished using
the authorized cables and/or connectors provided with the device or available from
the manufacturer/distributor for use with this device. Changes or modifications not
expressly approved by the manufacturer or party responsible for this FCC
compliance could void the user’s authority to operate the equipment.
21.5 cm from all persons, and must not be co-located or operated in conjunction
with any other antenna or transmitter. Installation should be accomplished using
the authorized cables and/or connectors provided with the device or available from
the manufacturer/distributor for use with this device. Changes or modifications not
expressly approved by the manufacturer or party responsible for this FCC
compliance could void the user’s authority to operate the equipment.
Installation Instructions
This manual deals only and specifically with a single device as a unit. The purpose of this chapter is to
describe the device and its identifiable parts so that the user is sufficiently familiar to interact with the
physical unit. Preliminary setup information provided below is intended for information and instruction of
the wireless LAN system administration personnel.
describe the device and its identifiable parts so that the user is sufficiently familiar to interact with the
physical unit. Preliminary setup information provided below is intended for information and instruction of
the wireless LAN system administration personnel.
It is intended that the user not open the unit. Any maintenance required is limited to the external enclosure
surface, cable connections, and to the management software (as described in Chapter 2) only.
surface, cable connections, and to the management software (as described in Chapter 2) only.
Minimum System and Component Requirements
To complete the configuration, you should have at least the following components: