EpiCom Co. Ltd. SDC-1000 Manuel D’Utilisation

Hereby, Epivalley co., LTD. declares that this SDC-1000 is in compliance with the essential requirements and other relevant provisions of Directive1999/5/EC. 

 

This USB modem is approved for use in normal size laptop computers only (typically with 12” or larger display screens). To comply with FCC RF exposure requirements, this modem should not be used 

in configurations that cannot maintain at least 12 mm from users and bystanders; for example, in certain laptop and tablet computers and configurations where the USB connectors are unable to provide or 
ensure the necessary separation is available between the modem and its users to satisfy compliance.   

The FCC has granted an Equipment Authorization for this HSDPA USB MODEM with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this 
USB modem is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov /oet / fcc id after searching on 

 

 

For more information about RF exposure, please visit the FCC website at 

www.fcc.gov

 

 

 

Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 
 

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference 
received. Including interference that may cause undesired operation. 
 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:   
 
- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
- Consult the dealer or an experienced radio/ tv technician for help.