D-Link Corporation IR626LA1 Manuel D’Utilisation

137

D-Link DIR-626L User Manual

 

 

 

 

 

 

 

 

 

 

 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, 

and (2) this device must accept any interference received, including interference that may cause undesired operation.

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are 

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there 

is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

 

- 

Reorient or relocate the receiving antenna.

 

- 

Increase the separation between the equipment and receiver.

 

- 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 

- 

Consult the dealer or an experienced radio/TV technician for help.

 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this 

equipment.

 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

 

Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed 

to US operation channels only.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with 

minimum distance 20cm between the radiator & your body.

 

 

 

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux 

conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un 

brouillage susceptible de provoquer un fonctionnement indésirable. 

 

 

 

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with 

minimum distance 20cm between the radiator & your body

Cet equipement est conforme aux limites d'exposition aux rayonnements IC etablies pour un environnement non controle. Cet equipement doit etre installe 

et utilise avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.