Chungear Industrial Co Ltd CE10206 Manuel D’Utilisation

 

(Please keep this instruction pamphlet.) 

 

 

 

 

 

1.Read and save these instructions. 

2.Please note that all fixed wiring appliances should be installed by a qualified electrician. 

3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall 

switch. 

4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan. 

5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection. 

6.This unit is to be used for the control of ceiling fan and in a AC110/120V 60Hz power supply only. 

7.Do not install in damp locations or immerse in water. (For indoor use only.) 

8.Do not pull on or cut leads shorter. 

9.Do not drop or bump the unit. 

10.  PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place 

as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of 

children. 

11.  CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable 

(rheostat) wall control. 

 

 

1.Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch” 

after installation. 

2.Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy 

comes up to cover the receiver and bracket. 

 

IMPORTANT 

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT 

(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. 

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.