JSW Pacific Corporation CCD-602S Manuel D’Utilisation

●  Select the correct channel which same as camera. 
●  The receiver is now ready for use. 
●  While having the USB jack plug into USB port (USB 2.0 recommended) the blue 

LED (USB    connection LED) will light up.    The RED LED is the channel LED. 

1.  Plug the USB into the USB socket of PC 

2.  Insert the CD-ROM provided with the package and Install CamGuard software 

and Driver     

-  Pentium IV or above 

-  256MB RAM or above 

-  USB 2.0 port 

-  CD-ROM drive (for installing driver & software) 

-  Color Monitor or LCD Display 

-  Windows X P or above 

System Installation   

When installing the camera, check the reception of the receiver before final 

installation. Have someone hold the camera in the area to be monitored. Have another 

person move the receiver to a variety of locations throughout the house to check 

reception. If interference or other problems occur, refer to the Troubleshooting Guide.   

-Select the channel (Channel 1-4, as indicated on Channel Label) to be used on both 

the camera and receiver. NOTE: Make sure the camera and receiver are set to the 

same channel (1, 2, 3 and 4).   

To set the channel selection switch on the camera, proceed as follows: -To set the 

channel selection switch, please take a pointed object, e.g. a ballpoint pen and select 

the desired channel switch (no. 1 to no. 4) to position "ON". The selected channel 

always remains active. Only one channel may be activated at one time.