Magnetrol R82 Manuel D’Utilisation
8
58-610 Model R82 Radar Transmitter
Select if Level or Level & Volume
Select the Units of measure for the
display (cm, inches, meters, feet).
display (cm, inches, meters, feet).
Enter the Sensor Offset value; the
distance from the top (100%) point of
the vessel to the Sensor Reference
point (bottom of an NPT thread, top
of a BSP thread, face of a flange).
distance from the top (100%) point of
the vessel to the Sensor Reference
point (bottom of an NPT thread, top
of a BSP thread, face of a flange).
Select the type of Tank Top; choices
are Flat, Horizontal cylinder, Dome,
Irregular, or Other (nonmetallic).
are Flat, Horizontal cylinder, Dome,
Irregular, or Other (nonmetallic).
Enter the exact Tank Height; inaccu-
rate values will create inaccurate level
readings.
rate values will create inaccurate level
readings.
Enter the Blocking Distance; the
distance close to the antenna where
measurement is unreliable. Minimum
value = 15" (375 mm)???? as meas-
ured from the process connection.
distance close to the antenna where
measurement is unreliable. Minimum
value = 15" (375 mm)???? as meas-
ured from the process connection.
Enter the Level Offset; the distance
at the bottom of the vessel where
measurement may be unreliable due
to heating coils, irregular bottom, etc.
at the bottom of the vessel where
measurement may be unreliable due
to heating coils, irregular bottom, etc.
Select the proper Dielectric range for
the process medium.
the process medium.
Select the value of Turbulence that
corresponds to the application.
corresponds to the application.
Select the Foam value that corre-
sponds to the application.
sponds to the application.
Select the Rate of Change value that
corresponds to the maximum rate the
level will rise or fall.
corresponds to the maximum rate the
level will rise or fall.
Examine the list of reflections detect-
ed by the transmitter to ensure the
actual level reflection is present. It
may be necessary to rotate the
launcher for optimal performance.
Run the Echo Rejection routine by
choosing the correct LEVEL thereby
cancelling all false reflections in the
vessel; ideally with tank empty.
ed by the transmitter to ensure the
actual level reflection is present. It
may be necessary to rotate the
launcher for optimal performance.
Run the Echo Rejection routine by
choosing the correct LEVEL thereby
cancelling all false reflections in the
vessel; ideally with tank empty.
Enter the minimum level value (0%)
for the 4 mA point.
for the 4 mA point.
Enter the maximum level (100%) for
the 20 mA point.
the 20 mA point.
Measure
Type
Level Units
(select)
Sensor Offset
xxxx
Tank Top
(select)
Tank Height
xxxx
Blocking Dist
xxxx
Level Offset
xxx.x
Dielectric
(select)
Turbulence
(select)
Foam
(select)
Rate of Change
(select)
Set 4mA
xx.x
Echo Profile
Set 20mA
xx.x
Sensor Offset
Tank Height
Blocking
Distance
Distance
Level
Offset
Offset
2
1
7
8
9
11
10
12
13
14
5
3
6
4
The following configuration entries are the minimum
required for configuration. The default password is 0.
required for configuration. The default password is 0.
1
2
3
4
5
6
8
9
10
11
12
13
14
7