Identiv Inc SDI010MOD02 Manuel D’Utilisation
SDI010-MOD OEM Integration Manual v1.0
Page 3 of 4
MOUNTING
It is recommended that the module is mounted so that the antenna that runs along the
periphery of the PCBA is parallel to the card placement position inside the device. The
board has two mounting holes located diagonally across. It is recommended to use nylon
(non-metallic) screws in these mounting holes. It is also recommended that there is no
metal in proximity of the antenna to ensure that signal strength is not degraded.
periphery of the PCBA is parallel to the card placement position inside the device. The
board has two mounting holes located diagonally across. It is recommended to use nylon
(non-metallic) screws in these mounting holes. It is also recommended that there is no
metal in proximity of the antenna to ensure that signal strength is not degraded.
CABLES & CONNECTORS
The board has two external connectors: one host USB header (J1) and a control header
(J2) to enable/disable the contact and/or contact less operation. The headers J1 and J2 are
located on the top of the board. The bottom of the board has the ISO7816 contact
connector below which the card guide mechanism has to be placed. It is recommended
that none of the cables pass over the antenna region.
(J2) to enable/disable the contact and/or contact less operation. The headers J1 and J2 are
located on the top of the board. The bottom of the board has the ISO7816 contact
connector below which the card guide mechanism has to be placed. It is recommended
that none of the cables pass over the antenna region.
LABELING
If the module is integrated in such a way that the label is not visible outside, then the
integrator has to display a exterior label referring to the enclosed module. The exterior
label can use wording such as the following: “Contains Transmitter Module FCC ID:
MBPSDI010MOD02” or “Contains FCC ID: MBPSDI010MOD02”. Any similar
wording that expresses the same meaning may be used.
integrator has to display a exterior label referring to the enclosed module. The exterior
label can use wording such as the following: “Contains Transmitter Module FCC ID:
MBPSDI010MOD02” or “Contains FCC ID: MBPSDI010MOD02”. Any similar
wording that expresses the same meaning may be used.
PRODUCT DOCUMENTATION
The end product documentation should include the FCC ID of the device and also include
the wording “The device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference (2) This
device must accept any interference received including interference that may cause
undesired operation.
the wording “The device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference (2) This
device must accept any interference received including interference that may cause
undesired operation.
TROUBLE SHOOTING
1. Unit does not power up
Check to ensure that the host USB cable is plugged in at proper orientation.
2. Host displays message that device is asking for more power
The device draws power from the host through the USB connector. The
maximum power draw is 150mA at 5V. So the device has to be plugged into a
root port or into a port on a self-powered hub. This message occurs when device
is plugged into a bus-powered hub.
maximum power draw is 150mA at 5V. So the device has to be plugged into a
root port or into a port on a self-powered hub. This message occurs when device
is plugged into a bus-powered hub.