Digi International Inc XB3C1 Manuel D’Utilisation
AT commands
Cellular commands
Digi XBee3 Cellular LTE Cat 1 Smart Modem User Guide
93
IM (IMEI)
Reads the device's International Mobile Equipment Identity (IMEI).
Parameter range
N/A
Default
Set in the factory
MN (Operator)
Reads the network operator on which the device is registered.
Parameter range
N/A
Default
AT&T
MV (Modem Firmware Version)
Read the firmware version string for cellular component communications. See the related
command.
Parameter range
N/A
Default
Set in the currently loaded firmware
DB (Cellular Signal Strength)
Reads the absolute value of the current signal strength to the cell tower in dB. If DB is blank, the XBee
Smart Modem has not received a signal strength from the cellular component.
Smart Modem has not received a signal strength from the cellular component.
Parameter range
0x71 - 0x33 (-113 dBm to -51 dBm) [read-only]
Default
N/A
AN (Access Point Name)
Specifies the packet data network that the modem uses for Internet connectivity. This information is
provided by your cellular network operator. After you set this value, applying changes with
provided by your cellular network operator. After you set this value, applying changes with
or
CN (Exit Command mode)
triggers a network reset.
Parameter range
1 - 100 ASCII characters