Turbocomm Tech Inc. IA300 Manuel D’Utilisation
Model : IA-300
Installation Guide
Page 1
SYSTEM REQUIRMENTS
Make sure your PC system meets ALL of the following minimum hardware and software
requirements:
requirements:
Hardware:
q
IBM PC/AT or compatible
q
Pentium 100Mhz or faster
q
30Mbytes available hard disk space or more
q
2x CD-ROM drive or better
q
32Mbyte available system memory or more
Software: Your Operating System must be one of the following:
ü Microsoft Windows 95.x – 95A, 95B
ü Microsoft Windows 98.x – 98, 98A
ü Microsoft Windows 98.x – 98, 98A
ü Microsoft Windows 98 2
nd
Edition
ü Microsoft NT – NT 4.0 Service Pack 3
BEFORE INSTALLATION
If you are installing PPPoA service for Win95A, 95B or Bridged Ethernet service for
Win95A, you need to upgrade your Dial-Up Networking (DUN) application to version
1.3 or above. Please refer to Appendix A on how to upgrade your system’s DUN.
1.3 or above. Please refer to Appendix A on how to upgrade your system’s DUN.
HARDWARE INSTALLATION
WARNING! To avoid possible damage to your IA-300 card you need to use an anti-static
grounding device or hold onto the metal chassis of the PC to provide anti-static grounding.
grounding device or hold onto the metal chassis of the PC to provide anti-static grounding.
1. Shut down the system and switch the power off.
2. Unplug the AC power cable from the PC.
3. Remove the cover from the PC chassis.
4. Unscrew the “slot cover bracket” from an unused PCI slot.
5. Insert the card into an empty PCI slot.
6. Firmly press the IA-300 card into the slot and secure the
2. Unplug the AC power cable from the PC.
3. Remove the cover from the PC chassis.
4. Unscrew the “slot cover bracket” from an unused PCI slot.
5. Insert the card into an empty PCI slot.
6. Firmly press the IA-300 card into the slot and secure the
card to the chassis with the chassis bracket screw.
7. Connect one end of a phone cable to the RJ-11 port on the
IA-300 card and plug the other end of the cable into the ADSL
data service.
data service.
8. Plug the power cable back into the PC system.
9. Power-up the PC and proceed to software installation.
9. Power-up the PC and proceed to software installation.
SOFTWARE INSTALLATION AND SERVICE CONFIGURATION
NOTE: You may need the Microsoft Windows Operating System installation files (CAB files)
to complete the installation. The CAB files are contained in the Microsoft’s system CD.
Some systems may have already installed the CAB files to the hard drive, but you should
have the Microsoft CD handy just in case.
NOTE: You may need the Microsoft Windows Operating System installation files (CAB files)
to complete the installation. The CAB files are contained in the Microsoft’s system CD.
Some systems may have already installed the CAB files to the hard drive, but you should
have the Microsoft CD handy just in case.
TO INSTALL POINT TO POINT PROTOCOL OVER ATM (RFC 2364) SERVICE
ð Win95A
go to page 2
ð Win95B
go to page 3
ð Win98, 98A
go to page 4
ð NT 4.0
go to page 6
TO INSTALL BRIDGED ETHERNET PROTOCOL OVER ATM (RFC 1483) SERVICE
ð Win95A
go to page 11
ð Win95B
go to page 12
ð Win98, 98A
go to page 13
ð NT 4.0
go to page 15
TO INSTALL CLASSICAL IP PROTOCOL OVER AT M (RFC 1577) SERVICE
ð Win98 SE
go to page 9