CyberTAN Technology Inc. RV215W Manuel D’Utilisation

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications.    However, there is no guarantee that interference will 

not occur in a particular installation.    If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one of the following measures: 

 

- 

Reorient or relocate the receiving antenna. 

- 

Increase the separation between the equipment and receiver. 

- 

Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 

- 

Consult the dealer or an experienced radio/TV technician for help. 

 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate this equipment. 

 

This transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

 

To comply with FCC/IC RF Exposure Limits set forth for an uncontrolled environment, the product 

must be installed and operated with a minimum separation distance (between nearby person(s) and 

radiating antenna) according to the following scenarios: 

1. 20cm minimum when the product is operated alone without co-transmitting with a plug-in 3G USB 

dongle device. 

2. 20cm minimum when the product is operated with a plug-in 3G USB device which has maximum of 

2W ERP output power. 3. For co-transmission scenario which is not covered above, please consult the 

RF technician or device supplier.