Shenzhen Lansefeiwu Technology Co. Ltd. BF10-A Manuel D’Utilisation
Shenzhen Lansefeiwu Technology Co., Ltd. BF10 DataSheet V2.0
Office：0086-755-29739852 Page 5 of 5
http://www.lanwind.com
Add: LongTaiLi Technology Building Room 304, Shenzhen, China
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Please notice that if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device
into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains FCC ID:
into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains FCC ID:
N8DBF10-A” any similar wording that expresses the same meaning may be used.