Sunpark Electronics Corp U1-1HOUVW Manuel D’Utilisation
E
LECTRONIC
B
ALLAST
I
NSTALLATION
I
NSTRUCTION
S
UNPARK
E
LECTRONICS
C
ORP.
1
Model Number: U1-1/HOUVW
CAUTIONARY NOTES: Do not use this equipment for other than intended use.
1. Verify that the line voltage matches the ballast voltage.
2. Installation to be made by a qualified person in accordance with applicable codes.
2. Installation to be made by a qualified person in accordance with applicable codes.
FCC Statement:
This device complies with part 18 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference. (2) This device must accept any interference received,
including interference that may cause undesired operation.
FCC Warning:
This equipment has been tested and found to comply with the limits for a consumer device, pursuant to
Part 18 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, used and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference in to radiate communications. However,
there is no guarantee that interference will not occur in a particular installation.
If these equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the used is encouraged to try to correct the interference
by one more of the following measures:
This device may not cause harmful interference. (2) This device must accept any interference received,
including interference that may cause undesired operation.
FCC Warning:
This equipment has been tested and found to comply with the limits for a consumer device, pursuant to
Part 18 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, used and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference in to radiate communications. However,
there is no guarantee that interference will not occur in a particular installation.
If these equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the used is encouraged to try to correct the interference
by one more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver in
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver in
connected.
Consult the dealer or an experienced radio/TV technician for help.
This product may cause interference to radio equipment and should not be installed near maritime safety
communication equipment or other critical navigation or communication equipment operating between
0.45-30 MHz.
Features
120-230 V AC input.
High power factor.
Flexibility in different size of HO amps.
Class P.
Sound rating A.
UL, cUL recognized. UL File # 177888.
Indoor Use.
Lamp Type and Power Consumption:
Lamp Type
Lamp Type
RGTS24HO
RGTS20HO
RGTS16HO
Power Consumption (Watts)
42W
35W
29W
Before Installation
1. Disconnect line voltage before installing or replacing lamp.
2. Ballast case must be grounded.
3. Place the ballast to a stable support and fix it.
Installation
1. Please connect the lamp with ballast according to the label on the ballast. Ballast supports
only the same type lamps specified on the product label.
2. Connect the AC power line. Connect the back wire to L terminal and white to N terminal of
the AC source.
3. The both connection of black and white power wire must be fully insulated.