Autostart AS5501 Manuel D’Utilisation
P. 2 User
Guide
Transmitter Part Number and Serial Number of the Remote Car
Starter Module
The boxes below contain information concerning your transmitter and Remote Car Starter.
We entered the part number of your transmitter for you. Should you need to order a new
transmitter, you will need to provide the transmitter part number which is printed below.
The second box contains the serial number of the Remote Car Starter. Please make sure that the
installer has entered the serial number in that box.
We entered the part number of your transmitter for you. Should you need to order a new
transmitter, you will need to provide the transmitter part number which is printed below.
The second box contains the serial number of the Remote Car Starter. Please make sure that the
installer has entered the serial number in that box.
Transmitter Part Number:
ASRF-5501G-100
The installer must use the space below to write the serial number of the Remote Car Starter and
the location of the valet switch (if installed):
the location of the valet switch (if installed):
Serial Number of the Remote Car Starter:
Location of the Valet Switch (if installed):
Location of the Valet Switch (if installed):
Introduction
This is a state-of-the-art remote starter system. The system is packed with advanced features such
as priority access to the driver’s door (commodity features) and the safe start children safety
feature. With many an advanced function, this product will satisfy any one of your expectations
from high-end commodity and security systems, without neglecting any standard feature commonly
offered by entry-level starters.
Using the Transmitter
Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two
independent vehicles equipped with identical remote starters (see Multi-car operation section on
page 7).
Remote-Starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
to inform you
that the remote starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain
ON
during the pre-programmed run time of the engine. If the
vehicle does not start at the first attempt, the system will shut down, wait a few seconds and try to
start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets (
Vehicle Presets (
Heater & Heated Seat
)
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Driving Off
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (Do not turn the key to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.