Guillemot 2960696-528 Manuel D’Utilisation

 

2/6 

Insert 3 1.5V type LR03 / AAA batteries in the battery compartment located at the back of the gamepad (14). 

 

 

 

•  POWER switch (13): 

- OFF position = the gamepad is off (and doesn’t use up batteries). 

- ON position = the gamepad is on. 

 
•  MOTORS switch (13): 

- OFF position = vibration mode is disabled (uses less battery power). 

- ON position = vibration mode is enabled (uses more battery power). 

 

 
•  CONNECT buttons (8 and 12) 

The connection between the gamepad and the receiver is established automatically. 

These 2 buttons allow you to establish a connection in case of failure or when using more than one T-

Wireless game pad at the same time. 

 

- Both LEDs are on = signal between the gamepad and the receiver. 

- Both LEDs flash quickly = no signal between the gamepad and the receiver. 

- Both LEDs are off = the gamepad is in standby mode or switched off. 

- Both LEDs flash slowly = change batteries. 

 

 
•  STANDBY MODE:  

-  The gamepad switches off automatically after 5 minutes of inactivity. 

-  To reactivate it, press the START button. 

 

 

 

1.  Connect the receiver’s PS2 Gameport connector (9) to port number 1 on your console. 

2.  Switch on your console. 

3.   Switch on your gamepad using the POWER ON switch (13). 

4.   Start up your game. 

 

You are now ready to play! 

 

ATTENTION: NEVER CONNECT THE USB CABLE (10) TO YOUR PLAYSTATION® 2