Wistron NeWeb Corporation DTVDWVB Manuel D’Utilisation
Tabletop Installation
The DIRECTV Wireless Video Bridge unit can be placed directly on a flat surface. Follow the IMPORTANT
SAFETY INSTRUCTIONS to find a proper place for the safe use of this product.
Wall Mount Installation
Two M4 x 20mm pan head screws (Thread type: Tapping) and expansion
anchors are included for wall mounting. You can call DIRECTV for detailed
information.
* Suitable masonry plugs may be required if attaching to a stone/brick wall.
anchors are included for wall mounting. You can call DIRECTV for detailed
information.
* Suitable masonry plugs may be required if attaching to a stone/brick wall.
To mount the unit on a wall, follow these instructions:
1. Ensure that the mounting location is free from hazards (electric
cables/wires/pipes/etc.).
2. Drill two pilot holes 26mm (about 1.0 inch) deep using a 3.6mm (about 0.14
inch) drill bit.
The two pilot holes must be level and spaced 55mm (about 2.17 inches)
apart horizontally.
apart horizontally.
When mounting on a stud partition wall, at least one of the mounting screws must be attached to a
wooden stud.
wooden stud.
3. If using the wall mount method:
Drive the screws through the mounting plate to be fastened and into the wall. (See step 1 below).
Align the two slots at the bottom of the unit with the two pins on the
mounting plate. (See step 2 below).
mounting plate. (See step 2 below).
Slide them until they lock in place. (See step 3 below).
Wall Mount Installation
DIRECTV Wireless Video Bridge
Installation Guide