ADC Telecommunications Inc. F0694-011 Manuel D’Utilisation

9-4

CONFIDENTIAL

Use AdminBrowser software to determine the current faults and warnings for all of 
the units in the system. To troubleshoot, start with the Fusion Wideband Main Hub’s 
faults AND warnings, then proceed to each of the Expansion Hubs, finishing with 
each of the RAUs.

NOTE: AdminBrowser v1.00 displays events (faults, warnings, or status 
messages) depending on your view preference. To change your view prefer-
ence, refer to Section 3.3.2, “View Preference,” on page 3-10.

Using AdminBrowser, click 

S

YSTEM

 I

NFORMATION

, then click 

G

ET

 F

AULTS

, W

ARNINGS

 

AND

 S

TATUSES

. This gives the present status of the system, depending upon View 

Preferences for all components.

Faults usually impact service; warnings may impact service; status messages contain 
information that should not be ignored, but indicate conditions that do not generally 
impact service.

NOTE: System commands can take longer to execute compared to compo-
nent commands.

NOTE: This RAU icon 

 indicates there is fault on the RAU. This icon 

 indicates a disconnected device. You cannot request status on a discon-

nected device.

Some actions that you can take, depending on the device fault or warning include, are 
as follows:

Hardware faults on Expansion Hub. 

– Try swapping fiber with another Expansion Hub at the Main Hub. 

– Try cleaning the fiber and the fiber ports with alcohol foam tip swab and 

compressed air. See Section , “To clean the fiber ports:,” on page -2.

– Power cycle the Expansion Hub.