Dayton Industrial Co. Ltd. CW500SD Manuel D’Utilisation
EN
EN
You can set:
Free
OK
Autolap
Target zone
• A target zone (heartbeat or speed) with alerts if you leave this
zone. To configure this information, select
zone and press on
OK.
Free
OK
Autolap
Target zone
Free
OK
Autolap
Target zone
• Regular lap information, at a pace to be determined (for
example: every Km or every 5 min).
The watch recaps your performance for each lap.
Free
OK
Autolap
Target zone
• Then select “
OK” to continue.
Search
Searching sensors
• The watch detects the sensors (accelerometer and
cardiofrequencemeter).
Once the sensors have been detected, you can start running, pressing on
OK to start the stopwatch.
• When running, you can choose between three
predefined displays. To change the current display,
press on
“ ” or “ ”. For a customised display,
please refer to the full instructions.
Press on
OK again to put an end to your session.
Continue
Stop
• You may choose to start running again, go to
Settings mode to modify your settings or confirm the
end of your run.
Should you choose the latter, the watch displays a
short report of your run and then asks whether you
want to save the data.
5. Recommendations for use.
See the full instructions in the support section on
kalenji.com.
Find your rhythm, enjoy your run.