DynaStream Innovations Inc. HRM1B Manuel D’Utilisation
HRM1 Heart Rate Monitor Use Instructions
Wearing the HRM1 Heart Rate Monitor
Wear the HRM1 Heart Rate Monitor directly on your skin, slightly below your breastbone. Wetting both sensors on the
back of the Heart Rate Monitor will result in optimum capture of heart rate pulses (wet with water or biogel). The strap
should fit snugly enough to remain in place during your exercise session. Proper placement of the Heart Rate Monitor is
also important for optimum capture of heart rate pulses.
back of the Heart Rate Monitor will result in optimum capture of heart rate pulses (wet with water or biogel). The strap
should fit snugly enough to remain in place during your exercise session. Proper placement of the Heart Rate Monitor is
also important for optimum capture of heart rate pulses.
Pairing the HRM1 Heart Rate Monitor with a Sports Monitoring Watch
The HRM1 Heart Rate Monitor must pair with an ANT-enabled Sports Monitoring Watch in order to display Heart Rate
data to the user. To do this:
data to the user. To do this:
•
Bring the HRM1 Heart Rate Monitor within 10-30 inches (25-75cm) of the Sports Monitoring Watch
•
Be sure to stand at least 72 inches (183cm) away from any other ANT-enabled Heart Rate Monitor
•
You can be in proximity to other ANT-enabled devices
•
After the HRM1 Heart Rate Monitor pairs with the Sports Monitoring Watch, the heart rate icon should appear
on the watch
on the watch
Specifications:
Size (max dimensions):
347 x 42 x 22mm (W x H x D)
Weight:
29g
Strap:
Detachable adjustable elastic strap, 425-641mm (L)
Power:
Single user-replaceable CR-2032 battery
Battery life:
3 years assuming use of 1 hr/day at 20°C
Storage temp:
-20°C to +70°C
Operating temp:
-10°C to +50°C
User-interface:
Auto on/off
RF frequency/protocol:
2.4 GHz / Dynastream ANT transmission protocol
Communication range:
> 3 m (receiver dependent)
Regulatory compliance:
FCC, IC, and CE ready
Product Warnings and Important Information
•
The HRM1 is intended for home or office use
•
Always consult your physician before beginning or modifying any exercise program. If you have a pacemaker,
defibrillator, or other electronic implanted device, consult your physician before using a heart rate monitor.
defibrillator, or other electronic implanted device, consult your physician before using a heart rate monitor.
•
The heart rate monitor is not a medical device, and could suffer from interference from external electrical
sources. The heart rate readings are for reference only and no responsibility can be accepted for the
consequences of erroneous readings.
sources. The heart rate readings are for reference only and no responsibility can be accepted for the
consequences of erroneous readings.
•
Contact your local waste department to properly dispose of the units and batteries. Do not incinerate.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Operational Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that