UTStarcom Korea Technologies Ltd. UTS-EA7T56B Manuel D’Utilisation
200mW RP Installation
RPC/RP Manual
WLL-200mW-RP-IN-1.0
25July2000
4
•
Use caution when installing or modifying telecommunications lines.
•
Never install telecommunications wiring during a lightning storm.
•
Never install telecommunications in wet locations.
•
Never touch uninsulated telecommunications wires or terminals unless the
telecommunications line has been disconnected at the network interface.
telecommunications line has been disconnected at the network interface.
•
Never touch uninsulated telecommunications wires or terminals carrying direct current or
ringing current or leave this wiring exposed. Protect and tape such wiring and terminals to
avoid risk of fire, electric shock, and injury to service personnel.
ringing current or leave this wiring exposed. Protect and tape such wiring and terminals to
avoid risk of fire, electric shock, and injury to service personnel.
•
Never push objects of any kind into this product through slots as they may touch dangerous
voltage points or short-out parts that could result in a risk of fire or electrical shock. Never
spill liquids of any kind on this product.
voltage points or short-out parts that could result in a risk of fire or electrical shock. Never
spill liquids of any kind on this product.
•
Slots and openings in the unit are provided for ventilation, to protect it from overheating.
These openings must not be blocked or covered. This product should not be placed in a
built-in installation unless proper ventilation is provided.
These openings must not be blocked or covered. This product should not be placed in a
built-in installation unless proper ventilation is provided.
•
To reduce the risk of an electrical shock, do not disassemble this product. Service should be
performed by trained personnel only. Opening or removing covers and/or circuit boards may
expose you to dangerous voltages or other risks. Incorrect re-assembly can cause electrical
shock when the unit is subsequently used.
performed by trained personnel only. Opening or removing covers and/or circuit boards may
expose you to dangerous voltages or other risks. Incorrect re-assembly can cause electrical
shock when the unit is subsequently used.
•
This equipment is intended for installation in restricted access locations where access is
controlled or where access can only be gained by service personnel with a key or tool.
Access to this equipment is restricted to qualified service personnel.
controlled or where access can only be gained by service personnel with a key or tool.
Access to this equipment is restricted to qualified service personnel.
Save These Instructions!