A Four Tech Co Ltd RFKB51 Manuel D’Utilisation

3

1. 

Make sure that your computer is turned off.

2. 

Connecting the Receiver’s Keyboard Cable:

(a)  When connecting to an IBM AT keyboard port, use the 5-pin DIN connector already attached to the

keyboard cable.

(b)  When connecting to a PS/2-style, 6-pin DIN keyboard port, remove the AT adapter.

(c)  Connect the receiver’s purple keyboard cable to the computer’s keyboard port.

3. 

Place the receiver eight inches (20 centimeters) from any

electromechanical device.

Before you can take advantage of the many features your keyboard offers, you

must install the driver. The driver is in the installation diskette that came

packaged with your mouse and keyboard

Windows 95/98/Me/2000/NT4.0 installation

Insert the installation diskette into your floppy disk drive.

Click the Start button and then click Run.

In the  Run dialog window, type A:\setup, where “A” is the letter of your floppy disk drive.

Click OK and follow the instructions on your screen to complete the installation.

The Wireless keyboard operates on two frequency channels.. Refer to the following to change the

frequency channel for your keyboard: Set the frequency channel on the receiver to 1 or 2. Set the

frequency channel on the keyboard to 1 or 2.

Each keyboard is assigned a unique ID code at manufacture, so the

receiver only picks up the signal from your mouse and prevents other Wireless keyboard radio signals from

operating on your computer. This feature can also be disabled, allowing other Wireless pointing devices to

operate your computer.