Honeywell International Inc. 950009 Manuel D’Utilisation

1. When power is applied from a newly installed battery, the decode LED lights and the scan LED blinks for approximately three 

seconds. Do 

 press any keys while the terminal is booting up.

2. The terminal initializes and the HHP splash screen displays for a few seconds. The Build numbers indicate the software 

version number.  

3. The system performs a hard reset. When the display activates again, follow the instructions that appear.

You are prompted to align the screen by tapping the target five times. Use the stylus provided by HHP. 

•

Alignment should always be performed with a stylus designed for touch screen applications. The small point is required for 
accurate calibration.

•

Press the stylus firmly into the center of the cross-hair target once and release. Do not “double-tap” the target. 

•

You can re-align the screen at any time by going to 

 > 

 > 

 tab > 

.  

After aligning the screen, follow the directions on the screen which take you through a simple exercise showing how to use the 
stylus and pop-up menus.

Build: 5.XX/5.XX/5.XX

Bootloader

Kernel

Keyboard

Tap the target firmly and accurately at 
each location on the screen. The target 
will continue to move until the screen is 
aligned.