Accton Technology SMC2552WG2 Manuel D’Utilisation
Command Line Interface
6-28
6
show hardware
This command displays the hardware version of the system.
Command Mode
Exec
Example
System Logging Commands
These commands are used to configure system logging on the access point.
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
WEB Redirect : DISABLED
DHCP Relay : DISABLED
==============================================================
SSH Server Port : 22
Telnet Server : ENABLED
WEB Redirect : DISABLED
DHCP Relay : DISABLED
==============================================================
Version Information
=========================================
Version: v4.3.2.2
Date : Dec 20 2005, 18:38:12
=========================================
Enterprise AP#
=========================================
Version: v4.3.2.2
Date : Dec 20 2005, 18:38:12
=========================================
Enterprise AP#
Enterprise AP#show hardware
Hardware Version Information
===========================================
Hardware version R01
===========================================
Enterprise AP#
===========================================
Hardware version R01
===========================================
Enterprise AP#
Table 6-6. System Logging Commands
Command
Function
Mode
Page
logging on
Controls logging of error messages
GC
logging host
Adds a syslog server host IP address that will receive
logging messages
GC
logging console
Initiates logging of error messages to the console
GC
logging level
Defines the minimum severity level for event logging GC
logging facility-type
Sets the facility type for remote logging of syslog
messages
GC
logging clear
Clears all log entries in access point memory
GC
show logging
Displays the state of logging
Exec
show event-log
Displays all log entries in access point memory
Exec