Accton Technology SMC2552WG2 Manuel D’Utilisation
System Configuration
5-46
5
Configuring SNMPv3 Targets
An SNMP v3 notification Target ID is specified by the SNMP v3 user, IP address,
and UDP port. A user-defined filter can also be assigned to specific targets to limit
the notifications received to specific MIB objects. (Note that the filter must first be
configured. see “Configuring SNMPv3 Trap Filters” on page 5-44)
and UDP port. A user-defined filter can also be assigned to specific targets to limit
the notifications received to specific MIB objects. (Note that the filter must first be
configured. see “Configuring SNMPv3 Trap Filters” on page 5-44)
To configure a new notification receiver target, click the New button. A new page
opens to configure the settings (see below). To edit an existing target, select the
radio button next to the entry in the table and then click the Edit button. To delete
targets, select the radio button next to the entry in the table and then click the Delete
button.
opens to configure the settings (see below). To edit an existing target, select the
radio button next to the entry in the table and then click the Edit button. To delete
targets, select the radio button next to the entry in the table and then click the Delete
button.
When you click on the New or Edit button in the SNMP Targets page, a new page
opens where the target parameters are configured. Define the parameters and
select a filter, if required. Note that the SNMP v3 user name must first be defined
(see “Configuring SNMPv3 Users” on page 5-42). Click Apply.
opens where the target parameters are configured. Define the parameters and
select a filter, if required. Note that the SNMP v3 user name must first be defined
(see “Configuring SNMPv3 Users” on page 5-42). Click Apply.
Note:
The Target ID cannot be changed in the Edit Target page. Only the New Target
page allows the Target ID to be configured.
page allows the Target ID to be configured.