Accton Technology WA4101ACCAA Manuel D’Utilisation
1-4
Introducing the HP ProCurve Wireless Access Point 420
Top of the Access Point
Top of the Access Point
In
tr
o
duc
in
g t
h
e
H
P
P
roC
ur
ve
Wi
re
less
Acc
e
ss
P
o
in
t
420
LEDs
Table 1-1.
Access Point LEDs
Access Point
LEDs
LEDs
State
Meaning
Power
(green)
(green)
On
The access point is receiving power.
Off
The access point is NOT receiving power.
Blinking*
The access point is undergoing self test or downloading software.
The self test and initialization are in progress after you have power cycled or reset
the access point. The access point is not operational until this LED stops blinking.
The self test and initialization are in progress after you have power cycled or reset
the access point. The access point is not operational until this LED stops blinking.
Blinking*
(prolonged)
(prolonged)
A component of the access point has failed its self test.
10/100-TX
On (green)
The RJ-45 port is enabled and receiving a link indication from a 100 Mbps device.
On (amber)
The RJ-45 port is enabled and receiving a link indication from a 10 Mbps device.
Off
The RJ-45 port has no active network cable connected, or is not receiving a signal.
Otherwise, the port may have been disabled through the access point console, or the
web browser interface.
Otherwise, the port may have been disabled through the access point console, or the
web browser interface.
Blinking*
The RJ-45 port is transmitting or receiving traffic.
Wireless
On
The wireless interface is enabled and receiving a link indication from a wireless client
Off
The wireless interface is not receiving a signal. Otherwise, the wireless interface may
have been disabled through the access point console, or the web browser interface.
have been disabled through the access point console, or the web browser interface.
Blinking*
The wireless interface is transmitting or receiving traffic.
* The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.