Accton Technology WA4101ACCAA Manuel D’Utilisation

2-6

Installing the Access Point 420
Installation Procedures

2.

Check the LEDs on the access point as described below.

When the access point is powered on, it performs its diagnostic self test. 
The self test takes approximately 50 seconds to complete.

LED Behavior:

•

The 10/100Base-TX and Wireless LEDs go off and then may come on 
again during phases of the self test. For the duration of the self test, 
the Power LED blinks.

 When the self test completes successfully:

•

The 

Power LED remains on.

•

The 

10/100Base-TX and Wireless LEDs on the top of the access point 

go into their normal operational mode:

–

If the ports are connected to active network devices, the LEDs 
should be on.

–

If the ports are not connected to active network devices, the LEDs 
stay off.

If the LED display is different than what is described above, especially if 
the 

Power LED does not stop blinking, the self test has not completed 

correctly. Refer to chapter 5, “Troubleshooting” for diagnostic help.

hp procurve

wireless

access point

Wireless LED

Ethernet LED

Power LED