Accton Technology WA4101ACCAA Manuel D’Utilisation
3-8
Getting Started With Access Point Configuration
Using the IP Address for Remote Access Point Management
Using the IP Address for Remote Access Point Management
Ge
ttin
g
S
ta
rte
d
With
Ac
c
e
ss
Po
in
t Co
n
fig
u
ra
tio
n
Using the IP Address for Remote Access
Point Management
Point Management
With your Access Point 420, you can use the access point’s IP address to
manage the access point from any PC that is on the same subnet as the access
point. You can use either a Telnet session or a standard web browser to manage
the access point.
manage the access point from any PC that is on the same subnet as the access
point. You can use either a Telnet session or a standard web browser to manage
the access point.
Starting a Telnet Session
To access the access point through a Telnet session, follow these steps:
1.
Make sure the access point is configured with an IP address and that the
access point is reachable from the PC that is running the Telnet session
(for example, use a
access point is reachable from the PC that is running the Telnet session
(for example, use a
ping command to the access point’s IP address).
2.
Start the Telnet program on a PC that is on the same subnet as the access
point and connect to the access point’s IP address.
point and connect to the access point’s IP address.
Example:
telnet 192.168.1.19
3.
Enter the user name and password. (The default user name is
admin and
the default password is null. You will then see the access point’s console
command (CLI) prompt, for example:
command (CLI) prompt, for example:
Enter
? to see a list of commands that can be executed at the prompt.
Entering any command followed by
? displays a list of options that are
available at that point in the command entry.
Starting a Web Browser Session
Your Access Point 420 can be managed through a graphical interface that you
can access from any PC or workstation on the same subnet as the access point.
Open a compatible browser and type the access point’s IP address as the URL.
(See “Using the Command Line Interface” on page 3-2 for information on
setting the IP address.) No additional software installation is required to make
this interface available; it is included in the access point’s onboard software.
can access from any PC or workstation on the same subnet as the access point.
Open a compatible browser and type the access point’s IP address as the URL.
(See “Using the Command Line Interface” on page 3-2 for information on
setting the IP address.) No additional software installation is required to make
this interface available; it is included in the access point’s onboard software.
Username: admin
Password:
HP ProCurve Access Point 420#
Password:
HP ProCurve Access Point 420#