Accton Technology WL463ACC Manuel D’Utilisation
3
Remove the antenna housing.
Grasp the inside edge of the antenna housing and pull up to disengage the housing from the
unit, as shown below. This part is no longer needed.
unit, as shown below. This part is no longer needed.
4
Install the radio board.
Holding the radio board at an angle, align the contact edge with the mini PCI connector on the unit. Make sure
the keying notch on the contact edge lines up with the key on the connector, as shown in the detail below. Slide
the board into the connector and press down gently until the two retainer clips snap into place.
the keying notch on the contact edge lines up with the key on the connector, as shown in the detail below. Slide
the board into the connector and press down gently until the two retainer clips snap into place.
WL-463 guide.fm Page 3 Tuesday, November 18, 2003 3:48 PM