Shenzhen Yichen Technology Development Co. Ltd. YC005 Manuel D’Utilisation

 

 

1) Turn off your desktop PC and disconnect the power. 

2) Open your PC’s case and locate an available PCI slot on the motherboard.Remove the metal slot cover 

on the back Of the PC. Check with your computermanufacturer for instructions if needed. 

3) Slide the PCI adapter into the PCI slot. Make sure that all of its pins are touching the slot’s contacts. 

Once the adapter is firmly in place, secure its fastening tab to your PC’s chassis with a mounting screw. 
Then, close your PC’s case. 

4) Reconnect your PC’s power and power on your desktop PC 

Connect USB adapter to the USB interface on your computer. 

1) Locate an available CardBus slot on your notebook PC. 

2) With the connector pin end facing the CardBus slot and the label facing up, slide the adapter into the 

CardBus slot until it locks in place. 

3) The Status LED should flash when the adapter is installed correctly.. 

1.  When “Found New Hardware Wizard” is prompted, click Cancel, then insert the Resource CD into 

your CD-ROM drive. Choose Wireless-N PCI/USB/Cardbus adapter driver , pitch on I accept the 
terms of the license agreement ,,then click Next to continue; 

2. 

Follow the Install Shield Wizard steps, and click the Finish button when done to reboot the system,Just 
confirmed it like below: