Honeywell International Inc. THM4000R02 Manuel D’Utilisation
Wireless System Installation Guide
69-2426—01
2
M28474
1
Install batteries in wireless devices
Install batteries in all devices. Make sure batteries are inserted properly (see polarity marks
on the devices).
on the devices).
2
Install cable and receiver
M28472A
Remote Controller
Portable Central Controller (optional): Install 3 fresh AA batteries
Outdoor air sensor (optional): Install 2 fresh AA
lithium
batteries
Install 2 fresh AA batteries
Install quick reference card
1 Before mounting indoor unit, connect cable to
the 5-pin CN105 connector on the control board
in the indoor unit.
in the indoor unit.
2 Mount indoor unit. Route cable to preferred
location of the wireless receiver.
3 Route cable through hole in base of wireless
receiver and attach to 5 pin connector on
receiver board.
receiver board.
4 Push the excess cable back through the indoor
unit or behind the wireless receiver. Do not cut
or modify the cable. Use zip tie connections on
back of receiver if needed.
or modify the cable. Use zip tie connections on
back of receiver if needed.
5 Mount wireless receiver next to the indoor unit
(see below) or in a remote location.
Mount in the orientations shown. Do not block vents.
MCR31400
X
X
OR
OR