Honeywell International Inc. THX9001R01 Manuel D’Utilisation
System Installation Guide
4
69-2688—01 I/O-CHTSTAT03
Install thermostat
1
Thermostat Mounting
Mount the thermostat approximately 5 feet from the floor on an interior wall using
the included screws and anchors. Drill 3/16" holes for drywall and 7/32" holes for
plaster. Do not install the thermostat where it can be affected by:
the included screws and anchors. Drill 3/16" holes for drywall and 7/32" holes for
plaster. Do not install the thermostat where it can be affected by:
• Drafts or dead spots behind doors and in corners.
• Hot or cold air from ducts.
• Radiant heat from sun or appliances.
• Concealed pipes and chimneys.
• Unheated (uncooled) areas such as an outside wall.
• Hot or cold air from ducts.
• Radiant heat from sun or appliances.
• Concealed pipes and chimneys.
• Unheated (uncooled) areas such as an outside wall.
Terminal Functions:
1 - Data 1
2 - Data 2
R - 24 volt power
C - 24 volt common
2 - Data 2
R - 24 volt power
C - 24 volt common
Wire Gauge:
18 gauge wire is recommended. Maximum wire distance between the ComfortNet
thermostat and the IFC should not exceed 100 feet using 18 gauge wire.
thermostat and the IFC should not exceed 100 feet using 18 gauge wire.
MCR29241
MCR33170
1
2
R
C
MCR33171
1
2
R
C