Wacom DTK-1300 Manuel D’Utilisation

Contents

Index

Contents

31

Index

31

CALIBRATING THE CINTIQ

For optimum performance, you must calibrate the Cintiq to align the screen cursor with the position of the 
pen on the screen. This is required to compensate for viewing angle, and to adjust for 

. Set Cintiq in 

its working position, then follow the below procedure.

Tip: 

To see the screen cursor slightly offset from the actual position of the pen tip, calibrate by clicking 
on a spot showing that offset from the crosshairs. For example, to have the screen cursor appear 2.5 
mm (1/10th of an inch) above and to the left of the pen tip, calibrate by clicking on a spot 2.5 mm (1/
10th of an inch) below and to the right of the crosshairs.

1. Open the Wacom Tablet control panel.

If more than one tablet or pen display is 
installed on your system, select the pen 
display you are working with from the 
T

ABLET

 list.

2. Select G

RIP

 P

EN

 from the T

OOL

 list. 

Then select the C

ALIBRATE

 tab.

3. If you are working with multiple monitors, 

select the M

ONITOR

 corresponding to 

your Cintiq. Only monitors that are set to 
one of the resolutions supported by 
Cintiq will appear in the list.

4. Click C

ALIBRATE

... to activate the 

calibration screen.

5. Hold the pen and position yourself as 

you normally do when working with the 
Cintiq. Use the pen tip to click on the 
center of the crosshairs in the upper-left 
corner.

6. Then click on the center of the crosshairs 

that are displayed in the upper-right, 
lower left, and lower right corners.

7. Test the alignment by positioning the pen 

at a few different points on the display. 
Click OK to accept the calibration. 
Click T

RY

 A

GAIN

 to recalibrate.

Crosshairs