Zebra Technologies Corporation RFID-M4E-01 Manuel D’Utilisation

LCD Error Messages

23063L-003 Rev. A

6/24/05

R110Xi/R170Xi User Guide

129

HEAD COLD

Caution • An improperly connected printhead data or power cable can 
cause this error message. The printhead can still be hot enough to cause 
severe burns. Allow the printhead to cool.

The printhead is under 
temperature.

Continue printing while the printhead reaches the 
correct operating temperature. If the error remains, 
the environment may be too cold for proper 
printing. Relocate the printer to a warmer area.

Printhead data cable is not 
properly connected.

Caution • You must turn off the printer before 
performing this procedure. Failure to do so can 
damage the printhead.

Turn off (O) the printer.

Disconnect and reconnect the data cable to the 
printhead.

Ensure that the cable connector is fully 
inserted into the printhead connector.

Turn on (I) the printer.

Caution • Observe proper electrostatic 
safety precautions when handling any 
static-sensitive components such as 
circuit boards and printheads.

OUT OF MEMORY

There is not enough memory to 
perform the function shown on 
the second line of the error 
message.

Turn the printer off then back on to clear memory, 
and try to print again. If the error recurs, there is 
insufficient memory for the label length, 
downloaded fonts or graphics, and images.

Ensure that the device, such as Flash memory or 
PCMCIA card, is installed and not write-protected 
or full. See 

Caution • Observe proper electrostatic 
safety precautions when handling any 
static-sensitive components such as 
circuit boards and printheads.

Ensure that the data is not directed to a device that 
is not installed or available.